This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
shifty_vu_shield [2010/02/06 01:33] macegr |
shifty_vu_shield [2015/05/22 00:51] macegr |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== | + | ====== |
{{shifty_vu_shield.jpg? | {{shifty_vu_shield.jpg? | ||
Line 8: | Line 8: | ||
^ Works with: | [[shiftbrite|ShiftBrites]], | ^ Works with: | [[shiftbrite|ShiftBrites]], | ||
^ Fits: | Arduino [[http:// | ^ Fits: | Arduino [[http:// | ||
- | ^ Power Supply: | + | ^ Power Supply: | 5.5V to 12V DC (ShiftBrite Header)\\ 5V (from Arduino) |
^ Pin Usage: | Analog 2, 3; Digital 9, 10, 11, 13; AREF, VIN, 5V, 3V3 | | ^ Pin Usage: | Analog 2, 3; Digital 9, 10, 11, 13; AREF, VIN, 5V, 3V3 | | ||
^ Inputs: | 3.5mm stereo jack, power via screw clamp terminals | ^ Inputs: | 3.5mm stereo jack, power via screw clamp terminals | ||
^ Outputs: | Filtered audio on Analog 2 and 3; SPI ShiftBrite chain | | ^ Outputs: | Filtered audio on Analog 2 and 3; SPI ShiftBrite chain | | ||
^ Other features: | Passthrough female headers and duplicate solder pads | | ^ Other features: | Passthrough female headers and duplicate solder pads | | ||
+ | |||
+ | ====== Assembly ====== | ||
+ | The passthrough headers are provided not soldered in place, to reduce damage in shipping and more flexible usage options for our customers. The headers must be soldered to the shield, as seen in the photo above. A good connection will not be made if the headers are merely poked through the shield into the Arduino, without soldering. This accounts for many of our tech support issues with the Shifty VU Shield. | ||
====== Power Connections ====== | ====== Power Connections ====== |